No announcement yet.

Mesh Force (Mesh with hole)

  • Filter
  • Time
  • Show
Clear All
new posts

  • Mesh Force (Mesh with hole)

    Hi there,
    i have a little problem with Mesh Force. I imported a mesh - from C4D - to SpeedTree (Cinema Edition, V 7.0.5) with an hole going through the whole mesh, with the intention to make vines growing inside it. The problem is that the vines stick only to some extent properly to the surfaces of the mesh but in some points they go through and do not adhere on itClick image for larger version

Name:	Screen shot_2.jpg
Views:	1
Size:	77.7 KB
ID:	3301Click image for larger version

Name:	Screen shot_3.jpg
Views:	1
Size:	79.3 KB
ID:	3302Click image for larger version

Name:	Screen shot_1.jpg
Views:	1
Size:	77.5 KB
ID:	3303 as they probably should.
    I tried to export the mesh to OBJ and FBX, but in both cases i get the same issue.
    There is by chance a way to fix it?

    Thank you in advance.


  • #2

    Increasing the "Segments:Accuracy" can help. You might also take a look at the force properties "Max iterations", "Max angle", and "Give up action". Those three properties control the balance of speed vs. accuracy in the computation. Simplifying the mesh can help as well.

    Hope this helps!