Announcement

Collapse
No announcement yet.

Tips of branches extend beyond the leaf material when using a frond

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Tips of branches extend beyond the leaf material when using a frond

    Hello - I'm in the process of building a Fragipani tree and have placed the leaf material and mesh I cut out on the tree using a frond generator. As you can see the tips of the branches exceed the material. I've tried to adjust the cutout and the anchor point but so far no luck. I appreciate your assistance!
    Mary

  • #2
    Hello,
    You can taper the tip of the branch off a bit sooner by using the radial profile curve. Just take the very end and drop it to 0.

    Most people don't use fronds this way in the upper canopy for a large broadleaf because you'd end up with so many polygons. Heading to branch properties>skin>spine only will hide the actual geometry so that it does not cost anything to use in the tree.

    hope this helps

    Comment

    Working...
    X