Announcement

Collapse
No announcement yet.

offset pivot

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • offset pivot

    Hi,

    I'm placing some leaves (custom cross cards) however i'm not getting an aligned pivot to the branch mesh.
    See in the image the pivot of the mesh on the right is set correctly but when the leaves are spread across the large branches the pivot is not aligned to the manipulator making the branch look like it's offset from the tree.

    thank you
    Attached Files

  • #2
    Managed to partially resolve the issue thanks to Sonia and adjusting the orientation of the branch. Just need to figure out how to sink the branch back into the tree now.
    Attached Files

    Comment


    • #3
      Hey there, if it's on a frond, you'll need to check the geometry>boundary>start or if it's on a leaf mesh you can use gen>shared>sink to push it in.

      Comment


      • #4
        thank you

        Comment

        Working...
        X